IPA MICRO-CLEAN 35 WIPE

Fast-Acting Surface Cleansing Wipe with 35% Isopropanol (IPA) High-PH Cleaner

IPA MICRO-CLEAN is a durable, pre-moistened nonabrasive towelette infused with a cleansing agent and isopropanol (IPA), an intermediate-level disinfectant. IPA Micro-Clean is effective reducing cross-contamination from non-porous surfaces.

USES

Intended to lower cross-contamination on external, non-porous surfaces and equipment at facilities such as:

  •  Transit Centers
  •  Airports, Seaports
  • Vehicles, Buses, Trains, Aircraft and Vessels
  • Schools
  • Corporate Campuses
  • Manufacturing Facilities
  • Community Infrastructure
  • Event Centers
  • Elevators
  • Public Spaces (Shopping Mall, Theatre)
  • Other populated locations

FEATURES

The Center of Disease Control and Prevention (CDC) and Homeland Security report IPA is effective on emerging contaminates.  Easy to apply by wiping and effective in 30 seconds to 1 minute.  Cleanser breaks down fatty cells and cuts thru grease, oils, dirt, sticky food, and other contaminants.

 

 

 

Untreated Treated

 

 

 

 

 

Dried milk fat on slide untreated surface

 

 

 

 

 

 

Milk fat breakdown after treatment

 

 

PACKAGING

180, 6”x12”, polypropylene wipes in a plastic pail

TECHNICAL

Properties @ 77°F (25°C)

Relative Density (S.G.) 0.87 – 0.97
Freeze Temperature, °F (°C) -10 (-23.3)
Initial Boiling Point, °F (°C) 172.00 (77.7)
For cleaning Water
Color Light Blue
Odor Alcohol
pH <11
Toxicity Yes, If consumed
Flashpoint, °F (°C), ASTM D93-11 95 (35)
Fumes During Treatment Light Alcohol
Environmental Hazards None
Thinners Required None
VOC (grams/Liter) 0.0
Drying Time 1-2 minutes

 

APPLICATION

Directions:  Use this product in a manner consistent with it labeling.

Dispensing Directions:  To start feed, remove cover.  From the center of the roll, pull up a towelette corner, twist into a point and thread through the blue hole located in the center of the cover.  Pull through about one (1) inch.  Replace cover.  Pull the first towelette up and tear off at an angle.  The remaining wipes will feed automatically, ready for the next use.  When not in use, keep blue cap securely closed to prevent evaporation.

Preparation:  Heavily soiled, greasy or rusted surfaces may require repeated pre-cleaning.  On hard, non-porous surfaces and articles, use a fresh towelette to thoroughly wet and pre-clean the surface.  Allow surfaces to remain wet for 1 minute or allow surfaces to air dry.

Method of Application:  Wipe the surface with a clean face of the towelette by folding as Illustrated below.

 

 

Fold in half again to make a quarter-fold wipe

 

 

Flatten the wipe

 

 

Fold the wipe in half

Gloves and eye protection recommended.

By folding towelette, several clean surface areas are produced allowing better contact with a clean towelette surface.

Use a new pre-wetted towelette at each new location.

Wipe in one direction, overlapping wiped area.

Wipe from cleanest to least clean regions of the surface.  Wipe systematically, for example, from top to bottom or far to near.

Keep track of which surfaces have been cleaned and which towelette areas are unused.  Always use the cleanest surface of the towelette.  If re-wiping, use a clean portion of the towelette, not the used towelette area.  Dispose of towelette according to site procedures.

Tools Needed:  IPA Micro-Clean can be applied using the following:

  • Saturate towelette, wipe in one direction folding wipe in half, then in quarter folds.
  • You may also Mist solid surface with IPA Micro-Clean spray. Allow to set up to 1 minute, then wipe in one direction, folding wipe in half, then in quarter folds with each stroke.

Coverage:  Coverage depends on type of surface, i.e. countertops, desktops, railings, doorknobs, actuator buttons, etc. or equipment complexity, printer, mouse, kitchen appliances, etc.  Do not use the same towelette on multiple surfaces.  This can spread germs and dirt from one space to another

Limitations:  Do not apply in the following cases:

  • Do not wipe Hot surfaces or approach open flame
  • Confined publicly occupied areas with poor ventilation
  • When sensitive papers, photographs, artwork, and furniture are unprotected.
  • Do not apply to porous or fine wood surfaces.
  • May damage shellac mounting of lensed instruments, may swell and harden rubber and certain plastic tubing after prolonged and repeated use.
  • Not intended to sterilize medical devices or apparatus.
  • Do not use without proper training and personal protective equipment (PPE).
  • Do not dilute or combine with other products.
  • Do not flush towelette down toilet.
  • Do not use towelette if it has become dry.
  • Not for consumption.

STORAGE

Two years shelf life when stored in cool, dry, well ventilated place in unopened container.  Always agitate or stir before using.  DO NOT ALLOW PRODUCT TO FREEZE.  Repeated freezing & thawing might cause damage to the product reducing effectiveness.

SAFETY

As with all chemical products, adequate precautions, training and care must be taken during use and storage.  Avoid direct contact with foodstuff, eyes, skin, and mouth.  Do not contact with open cuts or wounds.   Immune compromised or highly sensitive personnel should not use this product. Disposable protective suits are recommended.  Any direct contact with skin, eyes, etc. should be washed thoroughly with clean running water and soap.

 

Certain antidepressants may increase the effects of IPA, even in small amounts.  Should headache, dizziness, flushing, depression, nausea, vomiting, anesthesia, hypothermia, low blood pressure, shock, respiratory depression, or coma occur, move to fresh air and consider calling 911.

 

Always wear protective goggles and gloves.  OSHA  29 CFR 1910.132, Eye and Face Protection (29 CFR 1910.133), Hand Protection (29 CFR 1910.138), Respiratory Protection (29 CFR 1910.134) apply.  If suspected pathogens, follow 29 CFR 1910.1030.

WARRANTY

LIMITED WARRANTY:   International Chem-Crete Inc. warrants that, at the time and place we make shipment, our materials will be of good quality and will conform to our published specifications in force on the date of acceptance of the order.


DISCLAIMER: 
 The information contained herein is included for illustrative purposes only and to the best of our knowledge, is accurate and reliable. International Chem-Crete Inc. is not under any circumstances liable to connection with the use of information. As International Chem-Crete Inc. has no control over the use to which others may put its products, it is recommended that the products be tested to determine the suitability for specific applications and/or our information is valid in particular circumstances. Responsibility remains with the architect or engineer, contractor and owner of the design, application and proper installation of each product. Specifier and user shall determine the suitability of the product for specific application and assume all responsibility in connection therewith. AM041620-4